C2017 Cover Plate Liner to the casing of the 3/2C-DOHR Slurry Pump
Fit COVER PLATE LINER (017), and COVER PLATE (013), as described Below.
(a) Fit and tighten STUDS to tapped bosses in Cover Plate Liners (3/2 AH and 4/3 AH pumps only). If Studs are not square to the face of the Liner, screw a nut on the thread, and adjust by tapping lightly with a hammer.
(b) Place Cover Plate Liner on a flat surface, intake flange up. Liberally apply liquid soap or rubber lubricant to the intake flange and intake surface of the Cover Plate.
(c) Place Cover Plate over Cover Plate Liner, lining up Studs with corresponding holes (3/2 AH, 4/3 AH pumps only)), and push Cover Plate down until it engages firmly with the Liner. Place a small tyre lever, or similar, between intake surface and Liner, and lever flange out of Cover Plate intake. Fit Nuts to Studs, and tighten finger tight plus half a turn (max).
(d) Lift Cover Plate, with Liner fitted, and align holes with COVER PLATE BOLTS (015) assembled in the Frame Plate. Fit Nuts to Cover Plate Bolts, and tighten evenly, and in accordance with the tightening sequence indicated in Fig B of Appendix B, ensuring that Cover Plate lugs engage firmly with shoulders on Cover Plate Bolts.
Do Slurry Pump
Warman Pump
Warman Basic Part No.
Standard Warman Material Code
Part Name
3/2C-DOHR
3/2C-AHR
C2017
R55, R26, R33, S01
Cover Plate Liner
Before：EAM028 Expeller to 6/4E-DOHR Slurry Pump
